VIDEOS 》 Moon Base and Space Colonization - First we need fast InterPlanetary Internet

When you build a WAN Optimization device with TOFFEE the entire packet processing (data optimization) takes place in software layer or in other words more precisely Operating System kernel space. However if you have any compression or encryption hardware accelerator hardware card the parts of the TOFFEE packet processing modules can be offloaded to hardware layer and thus improving its efficiency.

Now I supported and finished complete GUI support of these parameters so that you can configure, store, reboot and the same will restore upon reboot. Besides I complete the TOFFEE-Mocha Big-Picture page. The Big picture is an interface where you can find all the configuration (or settings) of the TOFFEE-Mocha. This is almost similar to CISCO device show all command but in graphical representation. Sometimes a network admin can also print the Big Picture page and paste it near to the device to refer its settings.

When you choose to use your Raspberry Pi device as your IoT based remote weather station or if you are building Linux kernel (like kernel compilation) within the same, you need a good uninterrupted power source (UPS). But if you are using it on site or in some research camping location you can choose to power your Raspberry Pi device with your custom off-grid solar power source.

TOFFEE Optimized Satellite ISP Network: TOFFEE/TOFFEE-DataCenter can be used to optimize Satellite Networks (Satellite based Internet Networks, VoIP, Data, private leased-links) as shown. Ground station transponders can be connected via array of TOFFEE Devices and in the remote CPE can have dedicated or inbuilt TOFFEE with which you can establish a WAN Optimized Satellite Network Tunnel as shown.

The TOFFEE Project :: TOFFEE-Mocha :: Linux Open-Source WAN Emulator

In the previous update (17-Jun-2016) I discussed about the upcoming new Random Packet drop feature along with other completed features. Now I completed the entire TOFFEE-Mocha Random packet drop feature. I completed all the kernel components and the UI support of the same. And to make GUI settings more organized I split the earlier Basic-Settings page into two separate pages namely: Packet Drop and Packet Delay. So this way it is simple to understand settings according to their functionality.

When you build a WAN Optimization device with TOFFEE the entire packet processing (data optimization) takes place in software layer or in other words more precisely Operating System kernel space. However if you have any compression or encryption hardware accelerator hardware card the parts of the TOFFEE packet processing modules can be offloaded to hardware layer and thus improving its efficiency.

The TOFFEE Project :: TOFFEE-DataCenter :: Linux Open-Source WAN Optimization

TOFFEE can be used to optimize expensive Wireless backhaul network infrastructure. TOFFEE can be deployed over existing slow or often outdated old backhaul networks too. This will leverage mobile ISPs and network service providers to reduce their bulk IT CapEx and OpEx Costs.

VPN Networks may degrade network performance due to various packet processing overheads such as encryption and by adding extra network protocol header(s) (such as IPv4/IPv6, IPSec, etc). This may inflate near MTU sized packets and causes excessive packet fragmentation. Here are the few examples of packet processing involved in a VPN (or a VPN like) Tunnel. With TOFFEE you can optimize these packets even before they get processed on to a VPN device. TOFFEE optimizes packet contents (application payload and transport headers) so that these TOFFEE optimized packets when they get processed by VPN devices (or VPN software stack) they may never need further packet fragmentation. Here is a deployment scenario of TOFFEE with VPN devices.