DOCUMENTATION 》 Demo TOFFEE-DataCenter WAN Optimization VM Test Setup

Here is a list of TOFFEE-DataCenter features supported. TOFFEE-DataCenter currently supports some of the important features such as loss-less network data compression, Packet Deduplication (protocols/applications supported), Application Acceleration, TCP Acceleration, dynamic MTU optimization, data packaging, hardware offload support, etc.

Assume you have two sites (such as Site-A and Site-B) connected via slow/critical WAN link as shown below. You can optimize this link by saving the bandwidth as well possibly improve the speed. However, the WAN speed can be optimized only if the WAN link speeds are below that of the processing latency of your TOFFEE installed hardware. Assume your WAN link is 12Mbps, and assume the maximum WAN optimization speed/capacity of Raspberry Pi is 20Mbps, then your link will get speed optimization too. And in another case, assume your WAN link is 50Mbps, then using the Raspberry Pi as WAN Optimization device will actually increase the latency (i.e slows the WAN link). But in all the cases the bandwidth savings should be the same irrespective of the WAN link speed. In other words, if you want to cut down the WAN link costs via this WAN Optimization set up, you can always get it since it reduces the overall bandwidth in almost all the cases (including encrypted and pre-compressed data).

TrafficSqueezer is an open-source WAN Optimization project. TrafficSqueezer is mainly a research project which is started around mid-2006. It is initially started as a research (or prototype) code even before it is officially registered in Sourceforge.net. But this code is just primitive user-space raw socket modules. This is later refined and a pre-alpha version is created. Followed by which Alpha release. This prototype code is moved from user-space to Linux Kernel (Kernel Space) and then the journey begin in terms of making a serious WAN Optimization solution. Once the pre-beta and beta releases are complete the mainstream series is started.

When you choose to use your Raspberry Pi device as your IoT based remote weather station or if you are building Linux kernel (like kernel compilation) within the same, you need a good uninterrupted power source (UPS). But if you are using it on site or in some research camping location you can choose to power your Raspberry Pi device with your custom off-grid solar power source.

The TOFFEE Project :: TOFFEE-DataCenter :: Linux Open-Source WAN Optimization

Here is my power-consumption measurements of various devices deployed within my home lab. I measured via my kill-a-watt sort of power-meter which is fairly reliable and accurate. I checked its accuracy with various standard load such as Philips LED laps and other constant power-consuming devices to make sure that the power-meter is precise.

My 500GB Seagate Barracuda 7200RPM hard-drive suddenly started making mild clicking noise. I found this happening since morning. I was suspicious that something wrong in this drive and when I opened the Linux Disks app, I can find the cause of this issue. The disk is increasingly getting read errors. Besides I can see various other parameters such as Power-On Hours, Temperature, Head flying hours, etc.

Network Packet Queue or Buffer - Packet Flow Control, Fragmentation and MTU

Internet optimization through TOFFEE-DataCenter WAN Optimization Demo